Playing a Little Radio

The Elecraft KX1 is small enough to hold on my knee for operating.

Last weekend I really wanted to get out and play some radio. But, I also wanted to get my 4Runner cleaned up after a full summer of desert running (and the ensuing layers of dust) before the fall snows/rains come.

So, Saturday I worked some in the garage, at least enough to create a staging area for the radio equipment carried in the 4Runner. In the process, I opened a couple of the remaining cartons from my move to the duplex. I found my Garmin Montana 650t, which I planned to sell but now think might be a good GPS receiver to keep for trail driving.

I set the GPS unit and dash mount aside. I would deal with that later.

The Girl played around in the front and back yards while I unloaded the gear from the 4Runner and staged it on and around a folding table. With the 4Runner empty, I closed up the house, put The Girl in the rig, and we drove down to Minden to let Melvin’s do their thing. When I pulled into the queue, the operator gave me my ticket and said “That’s a lot of dust. I don’t know if we can get it all.”

“I will pay extra…”

“We’re just so busy…” He was right — I was probably sixth or seventh in the line.

“That’s OK, I’ll take what I can get. I’ve been in the desert a lot.” I left the keys on the dash and The Girl and I went into the shop to pay our bill. Whatever I got for my 25 bucks would be so much better than what I had.

Next for the 4Runner is getting the replacement tire in the shop and on the ground. (That was a left-over from the Bald Mountain activation. I broke a sidewall on a tire coming down the trail.) I am looking into a roof rack and air bags for the rear axle and the passenger’s seat has a parting seam in the leather that needs attention.

We waited outside (what a beautiful afternoon) for the rig to be washed. I listened to the local repeaters while folks chatted about small matters. There is a jammer in range of the Carson Valley repeater who was interfering with a couple of local hams. So they switched to another repeater that has coverage. I switched too so I could follow the conversation.

There was also some chatter on the CARLA network. A group of California hams assembled a complicated but useful network of repeaters that will cover most of the state and a lot of Nevada and Oregon. I monitor that network regularly as well.

The rig clean, The Girl and I visited Ronnie McD’s place and headed north toward home. She was antsy, but settled as I shared my fries with her. We pulled into the Koontz Avenue access to the Prison Hill Recreational Area and parked. I finished my late lunch (sharing of course) and then we got out for a walk.

It was a good day.

Sunday was rather a repeat of Saturday, except that I worked on some battery packs for my portable operations. I am reorganizing my portable radio kits and had some new materials in hand. I used some velcro to attach a power distribution box and a solar charge controller to the new 6Ah LFP battery. The velcro will permit (difficult) removal of the attached pieces if I decide that I do not like the setup. I also attached a distribution box to the 15Ah LFP battery, which is used when I want to run a 100w radio. The 6Ah battery will power my radios (and maybe a computer) with up to about 35w of power (or barefoot if I do not want to run power).

That only leaves the little 3Ah LFP battery to work with. I will probably add a charge controller and power distribution box to that pack as well. Or I might leave off the distribution box because I’ll likely be running on a barefoot radio.

I also got the Montana 650t updated and put onto a charger to see if the LiON battery is still serviceable. The unit has been in storage for several years so I am not sure about the battery.

The Girl was pestering, so I loaded her into the rig and we headed off to get in a walk. At the upper Silver Saddle Ranch staging area, I let her out, donned my EDC pack, and we headed down the trail. She ran herself hot and returned to me several times asking for a drink. But I knew that we would be at the Mexican Ditch in a few minutes and would not be on the trail that long before returning to the rig, where I can a water bottle for her.

She jumped into the ditch, of course, cooling herself and getting a drink. Then, as usual, she trotted past me and shook, giving me a shower as well. I always thank her for the shower and then we walked on.

At the ranch compound, I put her on-lead because there were a bunch of horse trailers parked in the lot. She is not sure about horses and I do not want an incident. But we saw no horses, yet the leash time was good because it gave us some practice working on-lead.

I gave her a bowl of water back at the rig and put her inside. I retrieved the KX1 go-box from the rig, threw a wire over the sage and bitter brush, and thew a counterpoise wire out on the ground. I sat on an old cottonwood stump, put the KX1 on my knee, and started chasing POTA (Parks on the Air) and SOTA (Summits on the Air) stations.

The Elecraft KX1 is a code-only radio, so I was using my newly acquired Morse Code skill. I worked five stations, including a park in Alabama being activated by one of CW Academy instructors, Ken K4EES with only about 3w of power. It is amazing what can be done with a little wire and a radio.

I thought about chasing a few more, but decided it was a good day. So I packed up my gear, got The Girl out for one last short outing, and we headed home. I made some early supper and fed her, then settled in to update my log and relax before the week started. It was a good day and a good weekend.

I keep the little Elecraft KX1 in this sealed box. In the box are the radio, battery, key, headphones, and an antenna.